UltraliteFRED
Installation Instructions
|
UltraliteFred
Without a Switch Directions
|
Each
ultraliteFRED kit includes a blinking red L.E.D., battery holder and 1
or 2 batteries depending on model. While every unit is tested before it
is approved for sale, things can happen during shipping. Please before
installing, test to insure that the L.E.D. is working by holding the wires
to the battery holder contacts, making sure the red tipped wire goes to
the red contact and the black goes to the non-marked contact side. We
have marked the battery holder and one of the wires red. The L.E.D. should
now blink. Determine the location you want to mount the L.E.D. and where
you will route the wires to the battery holder. Drill any necessary holes
and route the wires before mounting the L.E.D. The wires are very fragile
and sharp bends should be avoided. Do not mount the L.E.D. on the truck
as this movement may break the wires over time. Once the wires are routed,
mount the L.E.D. with a drop or two of CA glue. Next solder the wires
to the battery holder, red to red, black to black. Insert battery and
mount the battery holder with doubleback tape. If the ultraliteFRED does
not work for any reason, please return it for a replacement. *Please do
not attempt to remove the wires from the L.E.D. as it is extremely heat
sensitive and doing so will void your warranty.
Warning: This Kit CONTAINS LEAD which is known to the state of California to cause cancer, birth defects, or other reproductive harm. This kit is intended for Adults and is NOT for sale to or use by Children. |
UltraliteFred
With a Switch Directions
|
Each
ultraliteFRED kit includes a blinking red L.E.D., battery holder and batteries.
While every unit is tested before it is approved for sale, things can happen
during shipping. Please before installing, test to insure that the L.E.D.
is working by holding the wires to the battery holder contacts, making sure
the red tipped wire goes to the red contact and the black goes to the non-marked
contact side. We have marked the battery holder and one of the wires red.
The L.E.D. should now blink. Determine the location you want to mount the
L.E.D. and where you will route the wires to the battery holder. Drill any
necessary holes and route the wires before mounting the L.E.D. The wires
are very fragile and sharp bends should be avoided. Do not mount the L.E.D.
on the truck as this movement may break the wires over time. Once the wires
are routed, mount the L.E.D. with a drop or two of CA glue. Next solder
the wires to the battery holder, the switch should be connected to the
RED tipped wire and the RED contact of the battery holder, red to red, black
to black. Insert battery and mount the battery holder and switch with
doubleback tape. If the ultraliteFRED does not work for any reason, please
return it for a replacement. *Please do not attempt to remove the wires
from the L.E.D. as it is extremely heat sensitive and doing so will void
your warranty. Warning: This Kit CONTAINS LEAD which is known to the state of California to cause cancer, birth defects, or other reproductive harm. This kit is intended for Adults and is NOT for sale to or use by Children. |
*If
you have any problems or have any questions concerning installing the
switch or Fred contact us at greg@gatrworks.com
and we will be glad to help you any way we can.
|